Step 1: Install FSD & Enable SMB Server
  Download FSD 2.2 or higher. Follow the included instructions to install it on your Xbox 360.
  Run it and go to Setup > Settings > General Settings.
  Check the box next to "Enable Samba Server".
  Exit FSD and open it again. Leave it running.

Step 2: Configure 360 Content Manager
  Open 360 Content Manager and enter your 360's IP address under the FTP tab of settings if you haven't already.
  Test the connection to make sure the status says "Connection to FSD Successful".
  Save the settings.
  Click the "Show Xbox 360 Drive" button in the toolbar (green xbox logo) or press Alt+X.
  If you get an error message saying the program was unable to connect, exit and restart FSD on your 360.
  For best results, try to connect from your PC immediately after FSD opens on your 360.

Step 3: Scan Content Folder and Manage Files
  If you don't get an error message, look in the left side tree for a new entry called "Xbox 360".
  Expand it and navigate to the "Hdd1:\Content\0000000000000000" folder.
  This is where all games and DLC are stored. Pressing F4 will load ALL files on your 360 into the main view.
  Note that this can take some time depending on the speed of your network and how many files you have installed.


If you get a really nasty error message, screen capture it or copy and paste the details. Send an email to 
jtagcm@gmail.com with as much information as possible, including what you were doing and if anything worked afteward.
